Rods according to DIN 7335 Hgw 2088 (PF CC 42), plates to DIN 7335 Hgw 2082 (PF CC 201) NEMA „C” and tubes to DIN 7335 Hgw 2085 (PF CC 22) are produced. Cresol formaldehyde resin reinforced with textile fabric. It has the average characteristics described as fabric-filled phenolics, the stress mark from the molding instrument is visible on the outer diameter on the rods and tubes, therefore it has to be always machined to ensure circularity.
Natural colored, unfilled polyamide 12. In comparison with the polyamide 6 materials, it has a smaller degree of water absorption, the material is extremely tough, resistant to cyclic fatigue stress and it has good abrasion wear resistance.
DOCAMID 12 GF30
By adding glass fibers, the dimensional stability, hardness and strength of PA12 was improved in comparison with the “natural” version.
In comparison with the general polyamide 6 materials, the DOCAMID 4.6 material has a greater degree of rigidity and creep resistance in a wide temperature range. It can be readily used in a higher temperature range (80 - 150ºC), where the PA 6, PA 66, POM and PETP materials are not suitable in terms of dimensional stability, resistance wear, heat ageing and fatigue.
DOCAMID 6 E
It offers a favorable combination of strength, toughness, mechanical damping ability and wear resistance. All this is accompanied by good electric insulating and chemically resistant properties. Based on all of the above, the product can be regarded as a polyamide type “for general use”.
DOCAMID 6 G-H ELS
Composite version of magnesium catalitic cast PA 6, which is ranked to the conductive material family. Surface resistance is 106 - 107 Ω.
DOCAMID 6 G-H Esd
Nano- and microcomposite version of magnesium catalitic cast PA 6, which is ranked to the Esd (electrostatic dissipative) material family. Surface resistance is 109-1010 Ω. It has better abrasive wear resistance than natural cast PA 6.
DOCAMID 6 G-H HPV
Nano-composite cast polyamide 6 with improved sliding properties and wear resistance.
DOCAMID 6 GF30
In comparison with the pure PA 6, it has 30% glass fiber filling, as reinforcing material. Due to this, it has a greater degree of rigidity, dimensional stability and creep resistance. The maximum allowed operating temperature is higher, as well.
DOCAMID 6 MO
In comparison with the DOCAMID 6 E material, it has a higher degree of strength and rigidity due to the molybdenum disulphide (MoS2) content. Its heat and wear resistance is better, but its toughness and mechanical damping ability is worse. It can be readily machined with automatic cutting machines.
DOCAMID 66 CF20
Carbon-fibre reinforced, high mechanical strength polyamide 66. It has improved heat resistance and dimension stability, reduced surface and volume resisivity. It is classified as electrically conductive material.
DOCAMID 66 E
In comparison with the DOCAMID 6 E material, it has a higher degree of strength and rigidity. It has a better heat and adhesive wear resistance.